Remove Graphics Module (dGPU)

In order to remove the Input Modules from the Framework Laptop 16, begin by opening the Input Deck Latches on each side of the Laptop.

When the latches are open you can see the red printed on the latch.

To remove the Touchpad Spacers, slide them down and then they will lift away easily.

If there is resistance, make sure that the Input Deck Latches are open (see previous step).

After removing the Spacers, the Touchpad module can be removed in the same way. Gently slide it downwards from both sides and then lift away as shown.

To remove the Keyboard lift from the bottom using the pull tabs, and once lifted up the Keyboard module should lift out without resistance.

If your pull tabs are no longer attached, you can carefully use the spudger side of the Framework Screwdriver to lift the module away.

Remove your Input Modules or Spacers in the same way as the Keyboard, lifting from the bottom using the pull tabs as shown.

Remember to power off the system and unplug the USB-C power cable before you open the Interposer Door.

You can access the Interposer and change the Expansion Bay Module without removing the Mid Plate.

Flip open the Interposer Door using the pull tab provided.

Make sure that the door is closed again before closing the Laptop lid to avoid any risk of damage to the display.

Loosen the 4 captive fasteners which attach the Interposer for the Graphics Module. 2 of these might be hidden under the pull tab.

Once the fasteners are loosened, the Interposer can be lifted out using the pull tab as shown.

The Interposer should be easy to remove. If it feels stuck, make sure all 4 fasteners are fully loosened, and do not force it.

With the Interposer removed, loosen the 2 captive fasteners holding the Graphics Module in place.

With the Interposer installed, close the Interposer Door.

With the Framework Laptop 16 closed, turn the Laptop over and gently slide the Graphics Module up from the Expansion Bay slot as shown to remove it.

If the Graphics Module seems stuck do not force it. Make sure that the captive fasteners are correctly loosened (see previous steps).