Skip to main content

Initial Release

Minor Versionm

by Iroh

Parts

No parts specified.

    • Before beginning, make sure to shut down your Framework Laptop.

    • If the system is still powered on, you will see the chassis intrusion lights flashing red and blue when the Touchpad and Input Modules are removed.

    • In order to remove the Input Modules from the Framework Laptop 16, begin by opening the Input Deck Latches on each side of the Laptop.

    • When the latches are open you can see the red printed on the latch.

    • To remove the Touchpad Spacers, slide them down and then they will lift away easily.

    • If there is resistance, make sure that the Input Deck Latches are open (see previous step).

    • After removing the Spacers, the Touchpad module can be removed in the same way. Gently slide it downwards from both sides and then lift away as shown.

    • To remove the Keyboard lift from the bottom using the pull tabs, and once lifted up the Keyboard module should lift out without resistance.

    • If your pull tabs are no longer attached, you can carefully use the spudger side of the Framework Screwdriver to lift the module away.

    • Remove your Input Modules or Spacers in the same way as the Keyboard, lifting from the bottom using the pull tabs as shown.

    • Remember to power off the system and unplug the USB-C power cable before you open the Interposer Door.

    • You can access the Interposer and change the Expansion Bay Module without removing the Mid Plate.

    • Flip open the Interposer Door using the pull tab provided.

    • Make sure that the door is closed again before closing the Laptop lid to avoid any risk of damage to the display.

    • Loosen the 3 captive fasteners, and then use the pull tab to lift the Expansion Bay Shell Interposer out. These are captive fasteners, meaning that they will stay attached to the Interposer.

    • The Interposer should lift out easily. If you feel any resistance, check that all 3 fasteners are loosened, and do not force it.

    • Loosen the two captive fasteners that secure the Expansion Bay Shell.

    • Note that these fasteners are captive and will remain attached to the bracket.

    • With the Interposer installed, close the Interposer Door.

    • With the Framework Laptop 16 closed, turn the Laptop over and gently slide the Expansion Bay Shell up from the Expansion Bay slot as shown to remove it.

    • If the Expansion Bay Shell seems stuck do not force it. Make sure that the captive fasteners are correctly loosened (see previous steps).

Finish Line

One other person completed this guide.

Iroh

Member since: 6/7/24

47 Guides authored

Team

Framework Member of Framework

8 Members

151 Guides authored

0 Comments

Add Comment



View Statistics:

Past 24 Hours: 0

Past 7 Days: 7

Past 30 Days: 61

All Time: 678